Sam4s ER-5215 Specifications download pdf (Page 76)

74 • S-Mode Programming ER-5215M Electronic Cash Register v2.4

Clearing Memory

Before you use your ER-5215M for the first time, you must perform a memory all clear to insure that

all totals and counters are cleared and that the default program is installed.

CAUTION: The procedures described in this area are security sensitive. Clearing the

ER-5215M memory after the register is put into service will erase all programming as well as

totals and counters. Do not share this information with unauthorized users and distribute the

special SERVICE-Mode key only to those you may want to perform these functions.

Memory All Clear

1. Turn the power switch located on the right side of the register to the OFF position.

2. Turn the control lock to the S position.

3. Press and hold the key position where the CHECK key is located on the default

keyboard layout.

4. Continue to hold the CHECK key while turning the power switch to the ON position.

5. Press the upper left key of the keyboard, then the lower left key, then the upper right key,

and finally press the lower right key.

6. After a short delay, the printer will print the message: "RAM ALL CLEAR OK !" and

“OK” or “NG” for each of the four possible RAM locations. The default configuration

includes RAM 1 & 2 only, therefore RAM 3 & 4 will indicate “NG” unless expansion

RAM is added. Memory is cleared and the default program is installed.

Caution: After memory is cleared, the default program will set the register in the 5-key

configuration. If you are using 15 NLU keys, see “ER-5215M Keyboard Expansion” on page 81

to reset the 15 key configuration.

Clear All Totals and Counters

1. Turn the control lock to the S position.

2. Enter 20 and press the SBTL key.

2 0 SBTL

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 193 194

No comments

Sam4s ER-5215 Specifications Page 76